The corresponding port in IOTest changes from Open to Closed, as shown on port 4 in the example below. To test the inputs, close a switch on the IO device. Port A configures as input and port B configures as output. The IOTest application window is populated with data from the PMD device.Ĭlick Initialize Hardware. In Board #, select the number of the board be tested.Ĭlick Check for Hardware. The Omnivex I/O Hardware Test (IOTest) application window appears. Next, connect an IO device to the PMD, then test the connections.įrom the Omnivex software directory, located in: C:\Program Files\Omnivex\IOLink 3, start IOTest.EXE. The Board and serial number for the devices are shown in the window. The PMD devices appear in the InstaCal devices list. InstaCal detects the device and the Plug-and-Play Detection dialog box appears.Ĭlick OK. Install the PMD drivers, provided by Measurement Computing, onto the same computer which has IOLink installed.Ĭonnect both PMD devices to the computer.Ĭlick Start > Programs > Measurement Computing > InstaCal. To callibrate PMD devices for use with IOLink: Typically, only one PMD is connected to a computer at a time, so IOLink only recognizes the first device connected, but you can configure two PMD devices and IOLink so that both devices work on a single computer. If you want to purchase a device, you will find it under USB-1024, not PMD. Note: Measurement Computing have changed the name of these devices to USB-1024. You need more inputs and outputs than a single PMD-1024 device has, so you want to connect two of these devices to the same computer for use with IOLink.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |